Introduction To Road Spike Fixing Methods

May 13, 2025 Leave a message

 

Introduction to road spike fixing methods

 

 

1. Ground fixing method

 

The ground fixing method is to directly nail the road spike into the ground (asphalt pavement or cement pavement) to fix it. The operation steps are as follows:

(1). Use a hoe or other tool to dig a round hole with a diameter equivalent to the road spike and a depth of 5-10cm at the place where it needs to be fixed.

(2). Apply glue or other adhesives to the bottom of the road spike, then insert it into the round hole and hit it with a hammer or other tools to fix it firmly.

 

2. Installation base method

 

The installation base method is to fix the road spike through the base, which is suitable for installing road spikes at the same time as paving the road surface. The operation steps are as follows:

(1). Before the road surface is paved, drill a hole with a diameter equivalent to the road spike and a depth of 10-15cm at the location where the road spike needs to be installed.

(2). Put the road spike into the hole with the top exposed to the ground, and then fix the road spike with the help of the installation base at the bottom of the road spike.

(3). Finally, place the sign or roadblock to be installed on the top of the road spike.

 

news-750-750

 

3. Clamping fixation method

 

The clamping fixation method is to fix the road spikes by clamping devices, which is suitable for use in places that are difficult to fix, such as temporary slopes. The operation steps are as follows:

(1). Put the clamping device on the road spike and clamp the clamping device on the object to be fixed.

(2). Connect the road spikes and clamping devices tightly, and then use tools to press the casters at the bottom of the road spikes into the ground or add a fixing to ensure that they are firm and reliable.

 

4. Rubber fixation method

 

The rubber fixation method is to fix the road spikes by rubber gaskets and spiral rods, which is suitable for fixing on concrete pavement or other hard ground. The operation steps are as follows:

(1). Make a hole at the location where it needs to be fixed and insert the spiral rod into the hole.

(2). Put the rubber gasket on the spiral rod, and then insert the road spike on the spiral rod.

(3). Rotate the spiral rod until it is fixed.

 

The above are several common methods for fixing road spikes. In actual use, the appropriate fixing method should be selected according to the actual situation of the road spikes and the location where they need to be fixed to ensure that the road spikes are fixed firmly and reliably and play a safety role.

 

news-750-750