Why Threaded Spike Installation Is Different
The installation of railway screw spikes is different from that of traditional straight spikes. Because the shank carries a thread, the spike must be rotated into the sleeper or into a pre-installed sleeve. Special equipment such as electric screw machines, hydraulic wrenches or high-precision torque tools is required for screw-in installation. This method ensures a strong mechanical connection between the spike and the casing or sleeper and effectively improves the overall stability of the track structure.
Sleeper Preparation Before Installation
On wooden sleepers, a pilot hole is normally drilled first to guide the spike and prevent the sleeper from splitting. On concrete sleepers, a plastic dowel or cast-in insert must be in place before the screw spike is installed. The dowel diameter and depth must match the spike thread profile so that the spike develops its full holding force. Any damaged dowel should be replaced before installation, because a loose dowel reduces the pull-out resistance of the spike and can cause early loosening under traffic.
Torque Control and Retightening
During construction, the installation torque must be strictly controlled so that every spike is evenly stressed. Insufficient torque causes loosening under traffic, while excessive torque can strip the thread or crack the sleeper. On high-frequency or heavy-loaded lines, the spikes should be tightened a second time after initial installation to guarantee the continued stability of the connection. A calibrated torque wrench or an electric screw machine with torque limiting is recommended for consistent results across the whole section of track.
Inspection and Maintenance During Service
In daily railway maintenance, staff need to regularly check whether screw spikes are loose, broken, rusted or unstable. Loose spikes should be retightened to the specified torque, and damaged spikes should be replaced promptly. Replacing a faulty spike in time prevents further damage to the sleeper and avoids affecting the stability of the rail. Spikes installed in corrosive environments benefit from protective surface treatment such as zinc plating or hot-dip galvanizing, which slows the development of rust.
Common Installation Mistakes
A common mistake is driving a screw spike with a hammer instead of rotating it, which damages the thread and reduces holding power. Another mistake is applying extra torque to compensate for a worn dowel, which usually strips the thread or cracks the sleeper. Some crews also skip the second tightening pass on busy lines, which leads to early loosening. Mixing spikes of different lengths or diameters in the same track section should also be avoided, because it creates uneven clamping and gauge variation.
Frequently Asked Questions
What tools are needed to install threaded spikes? Electric screw machines, hydraulic wrenches or high-precision torque tools are normally used to rotate the spike into the sleeper or sleeve.
Why must the installation torque be controlled? Correct torque keeps every spike evenly stressed. Too little torque causes loosening, while too much torque can strip the thread or damage the sleeper.
Do screw spikes need a pilot hole in wooden sleepers? Yes, a pilot hole is normally drilled first to guide the spike and to prevent the wood from splitting during installation.
Why are spikes retightened a second time on busy lines? second tightening pass after initial installation compensates for early settlement and guarantees the continued stability of the connection.
How often should screw spikes be inspected? They should be checked regularly during routine maintenance for looseness, breakage, rust and instability, with damaged spikes replaced promptly.






